How to apply tile adhesive

Instructions for Usage

(1). Clean up walls and no delamination is allowed. Make sure walls are strong enough to be bonded with tiles.

(2). Mix Kam Chung tile adhesive powder and water in 3.3 : 1 proportion (approximately 7.5 liters of water for 25kg of powder).  Stir it well and make it in paste state. Motor stirrer is preferable. Stirring the mixture again after it being still for a few minutes can strengthen the bonding power.

(3). Use a scraper to smear the mixture evenly on a wall, 1 square meter each time, and then press a tile on it.

(4). The adhesive must be smeared on the back of tiles as well if they are with deep grains.

(5). A 2mm wide gap must be left between tiles and filled with waterproof joint mixture.

(6). Tile surface could be cleaned by moist cloth or sponge before adhesive dries out.